Omtech CW-5200 - Safety Information; Warning!; Caution!; Specifications

1
Safety Information
•
DO NOT
use this product with an incompatible, unstable, or ungrounded power supply. Only
use with well-grounded 3-prong 110V/60Hz outlets. Do not use a 3 to 2-prong adapter to
allow it to run from an ungrounded outlet.
•
DO NOT
run this chiller without rst lling it with an adequate amount of distilled water or
specially formulated laser-safe antifreeze. If neither is available, deionized water is preferable
to tap water, which can cause faster scaling and microbial growth that will shorten the life
expectancy of your chiller and attached devices.
• Place this chiller in a dry well-ventilated environment away from heat sources but warm
enough to avoid freezing temperatures.
• Ensure at least 1 ft. (30 cm) of open space next to its side air inlets.
• Ensure at least 1′8″ (50 cm) of open space above its top air outlet.
• When cooling a laser engraver, take care that this device does not cause the room's humidity
to exceed safe levels. Some smaller rooms may require additional ventilation to ensure safe
engraving.
• Remember that the
OUTLET
of the water chiller should connect to the
INLET
of the product
to be cooled. Similarly, the water chiller's inlet should be connected to the other machine's
water outlet.
Warning!
Caution!
Specications
Input Voltage
110–120 V~ 60 Hz
Dimensions
22.8×11.3×18.1 in. 58×28.8×46 cm
Compressor Power
0.67 hp 0.5 kW
Fan Power
0.03 hp 0.02 kW
Water Pump Power
0.04 hp 0.03 kW
Refrigeration Capacity
0.39 ton 1.39 kW
Refrigerant
R410A
Refrigerant Charge
10.6 oz. 300 g
Max. Working Temperature
113°F 45°C
Tank Capacity
1.6 gal 6 L
Inlet / Outlet Fitting
0.4 in. 10 mm
Max. Lift
42.7 ft. 13 m
Max. Flow
3.17 gal/min 12 L/min
Net Weight
57.3 lb. 26 kg