Onan JB Series - Troubleshooting Guide; Starting System Troubleshooting; Ignition System Troubleshooting; Fuel System Troubleshooting

AFTER WASHING" ELEMENT IN
4. Remove air cleaner baffle from cover, wash out dirt, and re-
install In cover.
FOAM ELEMENT TYPE (STANDARD)
5. Install cover with "TOP" up and tighten clamp.
f'..\
I ,
SOLVENT DIP IN ENGINE OIL AND
SQUEEZE
AS DRY
AS POSSIBLE. DUST CU
(PRE-CLEANER)
DRY ELEMENT TY.PE (OP.TIONAl)
1, Remove pre-cleaner and wash out dirt. Dry and re-install.
2, Loosen clamp and remove end cover.
3., Remove thumbscrew and take out element. Wash element in
detergent and water (use new element after 6 washings). Dry
'and
re-install.
Oil BATH TYPE (OPTIONAL)
1. Loosen bottom clamp, remove cleaner base and clean.
2, Refill base to oil level mark with fresh oil, same weight as used
KEEP OI,L-L ~~~~~~~®
AT THIS
in engine. '
AIR CL:EANERS
LEVEL
CAPANO OIL
LEVEL INDICATOR:,",,~~~!!~
KEEP OIL
AT THIS LEVEL __ . __ _
fULL
NEVER OPERATE
ENGINE WITH OIL
BELOW THIS LEVEL ';"-.-.-i-Ir--
LC1W
ALWAYS REPLACE
CAP TIGHTL Y. OR
OIL LEAKAGE MAY
OCCUR.
WARNING ~ Never check 011 level while engine II running.
______ • Hoi 011 dllcharged from the engine could
caule personal Injury.
OIL LEVEL INDICATOR
FUEL FILTER
FIGURE 21. MAINTENANCE PROCEDURES
21