FIGURE 36. REMOVING RING . .
FIGURE 38. MOUNTING OVERRUNNING CLUTCH*
REASSEMBLY
Inspect the parts carefully in accordance with the
procedure described in Inspection of
Parts.
Makeany
repairs necessary. Reassembly is the reverse, of
disassembly. The following precautions should, be
taken:
CAUTION
Parts containing lubricated bearings
must not be immersed in cleaning fluid to
prevent breakdown of lubricant. These parts should be
cleaned with a brush dipped in "Varsol" or any other
comparable mineral spirits;-Do not immerse overrunning
clutch in cleaning solvent. Thoroughly dry any parts that have
come into contact with the cleaning
fluid.
1.
Inspect brushes (Figure 37) and clean all parts
, carefully with a dry cloth and compressed air if it
is available.
2.
Apply 20 weight non-detergent oil to the armature
shaft and splines. Apply grease (Shell Albania No.
2 or equivalent) sparingly on the shift lever pin,
the joint of the shift lever and plunger, the plunger
and spacing washers-at the end of the shaft.-
3. To mount pverrurinirig clutch,.first insert pinion
stopper in. armature shaft; then install ring in
groove of the shaft.. For insertion of the
ring,
use
tool shown in Figure 38 and pull the pinion
stopper up.
4.
Use spacing washers to adjust the armature to
give end play of .004" to .020".
5. Tighten the thru bolts to a torque of 35 to 44 in-lbs.
6. Insert the shift lever as shown in Figure 39 into the
front bracket.
FIGURE 37. BRUSHES
FIGURE 39. INSTALLING SHIFT LEVER
31
To Next Page
Loading...
