The following symbols in this manual signal poten-
tially dangerous conditions to the operator or equip-
ment. Read this manual caretully. Know when these
conditions can exist. Then, take necessary steps to
protect personnel as well as equipment.
WARNINGl O
nan
uses
this symbol
1
throughout this manual to
warn of
possible
serious
personal injury.
^^y^jgg
This
symbol refers to
possible
equipment damage.
Fuels/electrical equipment, batteries, exhaust gases
and moving parts present potential hazards that could
result in serious, personal injury. Take care in follow-
ing these recommended procedures.
• Use Extreme Caution Near
Gasoline,
Gaseous
•Fuel
And
Diesel
Fuel.
A constant potential ex-
plosive
or
fire
hazard
exists.
Do not till fuel tank near unit with engine running.
Do not smoke or use open flame near the unit or
the tuel tank.
Be sure all fuel supplies have a positive shutoff
valve.
Fuel lines must be of steel piping, adequately
secured and free from leaks. Do not use copper
piping on flexible lines as copper becomes
hardened and brittle. Use black pipe on natural
gas or gaseous fuels, not on gasoline or diesel
fuels.
Piping at the engine should be approved
flexible line.
Have a fire extinguisher nearby. Be sure ex-
tinguisher is properly maintained and be familiar
with its proper use. Extinguishers rated ABC by
the NFPA are appropriate for all applications.
Consult the local fire department for the correct
type of extinguisher tor various applications.
• Guard Against
Electric
Shock
Remove electric power before removing protec-
tive shields or touching electrical equipment. Use
rubber insulative mats placed on dry wood plat-
forms over floors that are metal or concrete when
around electrical equipment. Do not wear damp
. clothing (particularly wet shoes) or allow skin
surfaces to be damp when handling electrical
equipment.
Jewelry is a good conductor ot electricity and
should be removed when working on electrical
equipment.
Use extreme caution when working on electrical
components. High voltages cause injury ordeath.
Follow all state and local electrical codes. Have all
electrical installations pertormed by a qualified
licensed electrician.
• Do Not Smoke While
Servicing
Batteries
Lead acid batteries emit a highly explosive
hydrogen gas that can be ignited by electrical
arcing or by smoking.
•
Exhaust
Gases
Are
Toxic
Provide an adequate exhaust system to properly
expel discharged gases. Check exhaust system
regularly tor leaks. Ensure that exhaust manifolds
are secure and not warped.
Be sure the unit is well ventilated.
•
Keep
The Unit And Surrounding Area
Clean.
Remove all oil deposits. Remove all unnecessary
grease and oil from the unit. Accumulated grease
and oil can cause overheating and subsequent
engine damage and may present a potential fire
hazard.
Dispose of oily rags. Keep the floor clean and dry.
• Protect Against
Moving
Parts.
Avoid moving parts of the unit. Loose jackets,
shirts or sleeves should not be permitted because
ot the danger of becoming caught in moving
parts.
Make sure all nuts and bolts are secure. Keep
power shields and guards in position.
If adjustments must be made while the unit is
running,
use extreme caution around hot
manifolds, moving parts, etc.
Do not work on this equipment when mentally or
physically fatigued.
To Next Page
Loading...
