WWW.ONEFORALL.COM 7
The Search Method
If your device does not respond to the ONE FOR ALL 2 after you have tried
all the codes listed for your brand, try searching for your code. The Search
M
ethod allows you to find the code for your device by scanning through all
t
he codes contained in the memory of the ONE FOR ALL 2. The Search
Method may also work if your brand is not listed at all.
Example: To search for your TV code:
1
Switch your television on (not on standby).
2 Press the TV key on your ONE FOR ALL 2.
3
Press and hold down MAGIC until the ONE FOR ALL 2’s
red light blinks twice (The red light will blink once and
then twice).
4
Press 9 9 1. The red light will blink twice.
5 Next, press POWER.
6
Aim the ONE FOR ALL 2 at your Television. Now press CH+
o
ver and over, until your Television turns off (everytime
you press the CH+ key the ONE FOR ALL 2 will send out a
POWER signal from the next code contained in the memo-
ry). You may have to press this key many times (up to 150
times) so please be patient. If you skip past a code, you
can go to the previous code(s) by pressing the CH- key.
Remember to keep pointing the ONE FOR ALL 2 at your
Television while pressing this key.
7 As soon as your television turns off, press MAGIC to store
the code.
Once you have Set-Up your ONE FOR ALL 2, you can blink back your
SET-UP CODE for future reference.
Example: To blink out your Television code:
1 Press TV once.
2 Press and hold MAGIC until the ONE FOR ALL 2’s red
light blinks twice (The red light will blink once and then
twice).
3 Press 9 9 0. The red light will blink twice.
4 For the first digit of your four-digit code, press 1 and
count all the red blinks. If there are no blinks, the digit is
"0".
5 For the second digit, press 2 and count all the red blinks.
If there are no blinks, the digit is "0".
6 For the third digit, press 3 and count all the red blinks.
If there are no blinks, the digit is "0".
7 For the fourth digit, press 4 and count
all the red blinks. If there are no blinks, the digit is "0".
Now you have your four-digit code.
Important notes:
- Most TV’s do not switch on pressing the POWER key. Please try pressing a
“number” key or the “TV-text off” key to switch your TV back on.
- To search for the code for your DVD player / DVD-R follow the instructions
above only press the DVD device key instead of TV during step 2.
- If your original remote control does not have a POWER key, press PLAY
instead of POWER during step 5.
To Next Page
Loading...
Need help?
General
