11
PROGRAMMING A MASTER POWER MACRO
(continued)
Clearing The Master Power Macro
1. Press and hold SET until the LED (red light) blinks twice,
then release
SET.
2. Enter
9 - 9 - 5. The LED will blink twice. Then press POWER
once.
3. Press and hold
SET until the LED blinks twice, then release
SET. The Master Power Macro is now cleared.
RE-ASSIGNING DEVICE KEYS
The One ForAll 4 Device Universal Remote Control can be set to control a
second PVR,VCR,or DVD player.For example,to control a TV,a cable box,
and
two DVD players,re-assign the unused VCR/PVR key to operate the second
DVD player as follows:
1. On the remote control,press and hold
SET until the LED
(red light) blinks twice, then release SET.
2. Enter
9 - 9 - 2.The LED will blink twice.
3. Press
DVD once.
4. Press
VCR/PVR once.The LED will blink twice. The VCR/PVR
key is now ready to be set up to control your second DVD
player.See
Programming Device Control on page 8.
To re-assign a second VCR or PVR (or DVR) to the unused
DVD key, repeat
steps 1 through 4.However, in step 3 substitute VCR/PVR for DVD, and in step 4
substitute
DVD for VCR/PVR.Now the DVD key will be ready to be set up as your
secondVCR or PVR (or DVR).See
Programming Device Control on page 8.
NOTE: Only one device can be assigned to an unused device key at a time.
USING CHANNEL SCAN
In the CBL/SAT or TV mode, use the FAV key to start a 3-second scan of all
channels.Or, if programmed,use the FAV key to scan only your favorite
channels to view a desired channel (see
Programming Favorite Channel Scan
on next page. )
1. Press
CBL/SAT or TV once.
URC4021 manual new IC:CTGAE4P 4021 manual booklet New IC 4/13/09 3:38 PM Page 11
To Next Page
Loading...
