Battery Tester BT300
12
Unstable battery shall be recharged and retested to avoid error. If
same test result appears after recharge and retest, the battery is
regarded as damaged, replace the battery.
Attention: If "Replace" resulted from IN-VEHICLE mode, it might be
the reason that vehicle cable is not well connected with the battery.
Ensure to cut off the cable and retest the battery under
OUT-OF-VEHICLE before making a decision to replace battery.
NOTE: After testing, if need to return, press RETURN key to directly
return to the startup interface.
After testing: if it's "IN-VEHICLE" test state, press OK key will bring
to Cranking Test.
3.4 Cranking Test
Tester prompts as following:
Starting the engine as prompted, tester will automatically complete
the cranking test and display the result.
Normally, cranking voltage value lower than 9.6V is regarded as
To Next Page
Loading...