Battery Tester BT300
14
Tester will do the following tests in a sequence:
For ripple test, tester will display the real time ripple and meanwhile,
shows ripple volt and charging volt values at the bottom line.
It takes approx. 6 seconds for the ripple test.
After the ripple test, tester will automatically start the loaded voltage
test.
Loaded Volt Test takes approx. 3 seconds, then it hints "Step on
accelerator to increase engine rotating speed"
Operate accordingly to increase the engine rotating speed to
3000turns or above, and keep for 5 seconds.
Tester starts the charging volt test after increase rev detected.
After the test finished, tester displays the effective charging volts,
ripple test result and charging test result.
To Next Page
Loading...