oneConcept 10031341 - Appliance Controls; Timer Setting; Swing Function; Cooling Function

8
TIMER
Press the TIMER button several times to set one of the following switch-o timers: 0.5 hour >
1 hour> 2 hours> 4 hours.
SWING
Press the button to swing the fan blade back and forth.
COOL
Press the button to activate the cooling by evaporation.
ANION
Press the button to refresh the air.
SPEED
Press the button several times to select one of the following speeds: Slow> Medium> Fast.
TYPE
Press the button several times to select one of the following modes: Normal> Natural
Wind> Night Mode.
Note: When you select a specic function, the appropriate indicator lights up. The buttons
on the remote control have the same function as the buttons on the control panel.
Cleaning and Care
• Before cleaning always remove the plug from the electrical socket.
• Please use a soft cloth to wipe the shell.Do not use water gasoline,or other chemical
solutions.
• Story and dry place to keep away from heat and sunlight.
• Loose scrow,You can clean wet curtain and lter after take out the back.
• Clean the body with a little mild detergent on a soft cloth..
• Cleaning the water tank add water into the water tank through water inlet,open the rub-
ber plug at the bottom of the water tank to drain the water o,wash several times.
• Clean the body with a little mild detergent on a solf cloth.