oneConcept Discman BT - Operation; Turning Unit Power On and Off; Play Mode Operations; Key Lock Functionality

OPERATION
Turning Unit Power On and O
• The display will show “no disc".
• To turn ON the unit, press the PLAY/PAUSE button, the LCD display will be on and then
read the inserted disc. If no disc is inserted or the inserted disc has an error, to turn OFF,
in CD stop mode press and hold the STOP for 3 seconds, display will go o.
NOTE: When the unit is stopped for approximately 10 seconds, the power will auto-
matically turned o.
Play Mode
1. In power o mode, press the CD door OPEN switch to open the CD door.
2. Insert a CD with the label side facing upward and then close the CD door.
3. Press the PLAY/PAUSE button to turn on the unit. Total number of tracks and playing
time in sequence and then start to play rst track automatically.
4. While playing, press the PLAY/PAUSE BUTTON to pause, the elapsed time will ash.
Press PLAY/PAUSE BUTTON again to resume playing
5. Rotate the VOLUME Up/Down to adjust volume level.
6. Press the STOP BUTTON to stop playing.
NOTE: Do not open the CD DOOR when a CD is playing.
To Enhance the Bass Sound: Set the BBS switch to the ON position.
NOTE: The bass boost performance will be increase or decrease depending on the
volume level.
Key lock
Move the HOLD slider on the back to the ON position to lock the buttons. Slide it to the
OFF position to unlock the buttons.
LCD information
At initial start up
• The disc will start playing and the display will show the playing time.
• The display will show the total number of tracks and total playing time. The rst track
number & instant.
• To review the total number of tracks and total playing time of the disc, press the STOP
button once.
During PLAY mode
• The track number and the elapsed time are displayed.
20