36
EN
ASSEMBLY
Preparation
Prepare a spacious area for installation, and put a shipping blanket on the area
to prevent scratches on the oor and the frame.
Attaching Side Brackets
Unpack the crossbar (A) and carefully place it on the oor upside-down. Attach
the side brackets (B) to the end of the crossbar (A) using the 2 screws (S-A), as
shown above with the Allen wrench.
Repeat the same process to assemble the other side bracket.
NOTE: The drawings of both of the crossbar and side brackets are the backside
of the components. Please make sure the crossbar and side brackets keep
facing down while installation, which is convenient for the further steps.
Shipping Blanket
Allen Wrench
To Next Page
Loading...