21
CARING FOR YOUR SYSTEM
WARNING: To avoid a possible shock, Do Not change the battery while the meter is connected to a computer with the
OneTouch® Interface Cable.
Insert the new battery
With the “+” side facing up toward you, place the battery in the compartment within the fold of the ribbon.
Push the battery until it snaps into place. Insert the two battery door tabs into the matching holes, and push
down until you hear the door click into place.
If the meter does not power on after you have replaced the battery, check that the battery is correctly installed
with the “+” side up. If the meter still does not power on, contact your local LifeScan Representative.
Check the time and date
After replacing the battery, turn the meter on by pressing and holding the ▼ button for ve seconds to access the set-up mode. The start-up
test screen will be briey displayed; then the date and time will appear in the top right corner of the display. Check that the time and date
are set correctly. If they are not, use the ▲ and ▼ buttons to re-set the meter before testing. See Setting the time and date in Section 2.
NOTE: Removing the meter battery will not aect your stored results. However, you may need to re-set the time and date.
Dispose of batteries according to your local environmental regulations
To Next Page
Loading...
