OneTouch UltraEasy - Caring for Your System

20
CARING FOR YOUR SYSTEM
 Caring for your system
Replacing the battery
Your OneTouch® UltraEasy™ Meter uses one 3.0 Volt CR 2032 lithium battery (or equivalent). Replacement batteries can be found
in most stores where batteries are sold. Your meter comes with the battery already installed. A battery icon appears in the far
right-hand side of the meter display to indicate low battery.
When there is enough power for a minimum of 100 more tests, the battery icon
will appear.
After each test and when reviewing past results, the battery icon will now ash to
remind you to change the battery as soon as possible.
When the battery icon is ashing by itself on the display, you cannot perform a
test. You must install a new battery before using your meter.
Replacing the battery

Remove the old battery
Start with the meter o. Open the battery door and pull up on the battery ribbon.