4
Setting up your system
Setting the time and date
Your OneTouch
®
UltraEasy
™
Meter comes with the time, date and unit of measure
pre-set. Before using your meter for the first time or if you change the meter battery, you
should check and update the time and date. Make sure you complete steps 1 to 6 below
to ensure your desired settings are saved.
Step 1
Turn the meter on, see page 3
After the test screen, the pre-set time and date will
appear on the display for five seconds.
The hour will now start flashing.
NOTE: If a setting does not need to be updated, simply wait five seconds. The meter
display will automatically advance to the next setting.
æ
WARNING: If your display shows mg/dL rather than mmol/L, contact Customer Care.
You cannot change the unit of measure. Use of the wrong unit of measure may cause you
to misinterpret your blood glucose level, and may lead to incorrect treatment.
DCO_06397001C_OTUE_OB_GB.qxd 4/13/07 3:18 PM Page 4
To Next Page
Loading...
