Installation & Preparation
Installation & Preparation
-6-
Install the washing machine
on a leveled and firm space.
Adjust washing machine
level by loosening or
tightening the leg adjuster
provided on the right hand
side of the bottom of the
washing machine.
See if the level on the washing
machine is correct.
Keep the
machine
more than
20 cm away
from the
walls to
prevent
noise.
Insert sound
absorption
plate into
the slot at
the Bottom
of the machine.
Horizontal tap
Extension tap
Square tap
Untighten the upper
connector screw and
the middle connector.
In case the diameter of
the tap is large remove
the guide plate
Connector
Fixing screw
Rubber
packing
Middle
Connector
Guide plate
Connector
Push the upper connector
up till the rubber packing is
in tight contact with the Tap.
Then tighten the 4 screws.
Turn the middle connector to
ensure no water leakage.
Inside rubber
packing
Connector
Middle
connector
Check to see if there is a rubber seal inside the connector.
Check the water hose to the inlet valve of the washing
machine, and then lock it by turning the hose connecting part.
To separate the water supply
hose from middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Connect the water supply hose
to the middle connector, pushing
the plate up.
Pusher
Connect the Inlet Hose
Connect the Inlet Hose
Hose
Connector
Inside rubber
packing
To Next Page
Loading...
Need help?
General
