1110
OPERATIONS
Vent Control
CLOSE VENT OPEN
CLOSE OPEN
Vertical air flow adjustment (manually)
The Vent control is located above the control knobs. The operation is different
on different models (see below figures).
For maximum cooling efficiency, CLOSE the vent. This will allow internal air circulation.
OPEN the vent to discharge stale air.
To open the vent, pull the lever toward you To open the vent, set the lever to the right position.
To close it, push it in. To close it, set the lever in the left position.
To adjust vertical air flow direction, adjust any one of the horizontal
louver blades. When adjusting the horizontal louver blades up and
down, always keep the top or bottom blades horizontal. This can
effectively prevent water droplets condensing on the front panel of
the unit.
SAFETY PRECAUTIONS
Plug in the power plug
properly.
Do not operate or stop the
unit by inserting or pulling
out the power plug.
Do not damage or use an
unspecified power cord.
Otherwise , it will cause electric
shock or fire due to heat
generation or electrica l shock.
It wil l cause electrica l shock or fire
due to hea t generation.
It will caus e electrica l shock or fire.
If th e supply cor d is damaged, it
must be replaced by a special cord
or assembly availabl e fro m the
manufacture r or its servic e agent.
Do not modify power cord
length or share the outlet
with other appliances.
Do not operate with wet
hands or in damp
environment.
Do not direct airflow at room
occupants only.
It wil l cause electrica l shock or
fire due to heat generation.
It ma y cause electrica l shock.
Thi s coul d damag e you r health.
Never touch th e metal parts
of th e uni t when removing
the filter.
Do no t clean the air
conditioner with water.
Ventilate wel l when used
together with a stive , etc.
I t may cause a n injury. Water may enter th e uni t and
degrade th e insulation . It may
caus e a n electri c shock.
An oxyge n shortag e may occur.
To prevent injury to the user or other people and property damage, the following instructions must
be followed.
Ÿ Incorrect operation due to ignoring of instruction will cause harm or damage, the seriousness
is classified by the following indications.
To Next Page
Loading...
