Onion Omega2 User Manual (English)

To Next Page

Follow along with this guide to set up your Omega2 for the first time. We’ll first

learn how to properly connect your Omega to a Dock and power it up. Then we’ll

connect to it to use the Setup Wizard to have it connect to your WiFi network and

then do some updates.

If you experience issues at any point in the process, try checking our

Troublshooting guide.

This guide assumes you have an Omega and a Dock. If you didn’t purchase a

Dock, follow our guide on powering the Omega with no Dock.

Unpack

Unpack the Omega and Dock from their boxes

Need help?

Do you have a question about the Onion Omega2 and is the answer not in the manual?

Onion Omega2 Specifications

General

Unpack the Omega and Dock from their boxes.

Plug the Omega into the socket on the Dock.

Connect the Omega and Dock to a power source via microUSB.

Turn on the Omega using the switch on the Dock.

Monitor the amber LED to confirm the Omega has completed booting.

Install necessary programs for browser access to the Omega.

Locate the Omega's unique name from its MAC address sticker.

Connect your computer to the Omega's WiFi access point.

Navigate to the Omega's setup wizard URL in a browser.

Upgrade Omega to the latest firmware and install the Console.

Confirmation of successful setup and next steps.

Troubleshooting steps if the Setup Wizard fails.