After Sales Support TEL: 1300 886 649
3
NOTES:
- Choose the mounting location where the unit will not interfere with
the normal driving function of the driver.
- Before nally installing the unit, connect the wiring temporarily
and make sure it is all connected up properly and the unit and the
system work properly.
- Use only the parts included with the unit to ensure proper installa-
tion. The use of unauthorised parts can cause malfunctions.
- Consult with your nearest dealer if installation requires the drilling of
holes or other modications of the vehicle.
- Install the unit where it does not get in the driver’s way and cannot
injure the passenger if there is a sudden stop, like an emergency
stop.
- If installation angle exceeds 30° from horizontal, the unit might not
give its optimum performance
- Avoid installing the unit where it would be subject to high
temperature, such as from direct sunlight, or from hot air, from
the heater, or where it would be subject to dust, dirt or excessive
vibration.
Din Front/Rear-Mount
This unit can be properly installed either from ‘Front’ (conventional
DIN Front-mount) or ‘Rear’ (DIN Rear-mount installation, utilising
threaded screw holes at the sides of the unit chassis).
For details, refer to the following illustrated installation methods.
Take out the screw before installation:
Installation
Before installing the unit,
please remove the two screws.
To Next Page
Loading...