Need help?Do you have a question about the Onix CH-2000D and is the answer not in the manual?
No assembly is required as the heater comes pre-assembled and ready-to-use.
Instructions for wall mounting the convection heater using the provided kit.
Provides protection against stray objects touching the heating elements.
Set the switch to 750W, 1250W, or both for 2000W high heat.
Adjust the dial to select the desired temperature.
A sensor will turn the heater off if it is overheating.
The heater operates in near silence.
Operate from the floor or mount onto a wall for convenience.
To Next Page
General
