Connecting Other Components —Continued
17
Connecting a TV
The CD receiver has a VIDEO OUT jack, which outputs video signal.
When you see the contents of “videos” and “photos” in your iPod on TV, connect the cable as follows.
Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the CD receiver may cause a momentary power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem, plug the CD receiver into a different branch circuit.
Plug the power cord into a suitable wall outlet.
The STANDBY indicator lights up.
First Time Setup
AccuClock - Automatic Clock Setting
For the AccuClock function to work properly, the CD receiver must be able to receive RDS radio stations, which
means an FM antenna must be connected. Be sure to connect an FM antenna before plugging in the power cord
(see pages 13 and 14).
The very first time you plug the power cord into a wall outlet, the AccuClock function automatically searches for
an RDS radio station that’s broadcasting CT (Clock Time) information and sets the clock accordingly. While the
CT information is being received, “AccuClock…” appears dimly on the display, as shown. Note that it may take
several minutes to set the clock.
If the clock is set successfully, the day and time will be displayed brightly for 2 seconds, as shown.
The AccuClock function automatically updates the clock daily at 2:00, 3:00, and 14:00.
If for some reason the clock cannot be set automatically, see “Setting the Clock” on page 42.
To wall outlet
Power cord (The figure varies from country to country.)
To Next Page
Loading...
Need help?
General
