Onkyo EQ-540 - Product Specifications Overview; Equalizer Section Specs; Oscillator & Mic Amp Specs; General Unit Specifications

SPECIFICATIONS
EQUALIZER SECTION
Input:
Output:
Max. output:
Frequency response:
Total harmonic distortion:
Signal to noise ratio:
Adjustable range:
Gain:
OSCILLATOR SECTION
Step frequencies:
Frequency response:
Output voltage:
МІС. AMP. SECTION
Input:
Frequency response:
Max. input:
OTHERS
AC outlet:
Power supply:
Dimensions:
Weight:
Sensitivity (FLAT): 150 mV
Impedance: 50 kohms
Voltage (FLAT): 150 mV
Impedance: 1 kohm
More than 5 V, 20 Hz ~ 20 kHz, 0,05% THD.
+0/-0.5 dB, 10 Hz — 35 kHz
Less than 0.01%, 20 Hz — 20 kHz, 1.5 V output (FLAT)
100 dB, 1.5 V output, IHF-A, input short
+6dB/+12dB
0 dB to —20 dB
32 Hz, 64 Hz, 125 Hz, 250 Hz, 500 Hz, 1 kHz, 2 kHz, 4 kHz,
8 kHz, 16 kHz
+1 dB, 32 Hz — 16 kHz
150 mV
Sensitivity: 0.2 mV
Impedance: 50 kohms
*0/—1 dB, 20 Hz - 30 kHz
100 mV
200 watts (UNSWITCHED)
AC 120 V, 60 Hz
435 (W) x 131 (H) x 362 (D) mm
17-1/8" x 5-3/16" x 14-1/4”
5.7 kg, 12.6 lbs.
Specifications and features are subject to change without notice.
PRECAUTIONS
1. Replacing the lamps
This unit uses the lamps listed below.
CIRCUIT NO. PART NO.
PL101 210195
DESCRIPTION
PL-AS-EQ540
2. Insulation resistance measurement
Connect the insulating-resistance tester between the plug of power supply cable and the screw on the bottom board.
Specifications; 500V, more than 10 MQ
3. Voltage selector (Rear panel)
Worldwide models are equipped with a voltage selector to conform with local power supplies.
Be sure to set this switch to match the voltage of the power supply in your area before turning the power switch
on.
Voltage is changed by sliding the groove in the switch with a screwdriver to the right or left.
Confirm that the switch has been moved all the way to the right or left before turning the power switch on.
Models without a voltage selector can only be used in areas where the power supply is the same as that of the
unit.
220% ~ 120V ~ 220V ~ 120% ~
at АС 120V at АС 220V
-2-