Onkyo ES-600PRO

Section Names and Functions
(Remote Control Transmitter)
Remote Control Transmitter (RC-199M)
The following buttons are used to controi the ES-600PRO
@)
Operation Indicators
The two indicators function as guides when codes are stored
in the remote control transmitier. If the encoding process is
incomplete or the battery depleted the LEARNED/SENDING
indicator will flash whenever a button is pressed.
LEARN/A/B Switch
A: Set to this position during operatian for (3) — ay buttons
and other white characters.
B: tn this position, al! buttons are operable except (3) through
) .
LEARN: Use this position to input the code of another remote
control transmitter.
Test Tone (TEST)
Test tone on/off.
Surround Mode (SURROUND MODE)
Surround mode selector button. Operation is the same as that
of the surround mode button of the front panel.
Surround Mode On/Off Button (ON/OFF)
OFF: Operation is the same as that of the BY.PASS button of
the front panel.
ON: The status prior to turning the mode off is resumed.
Center Speaker On/Off Button (CENTER ON/OFF)
Turns the Center Speaker on and off when adjusting the input
balance.
Center Level (CENTER LEVEL a / WW)
Adjust the center speaker volume.
4 : Increases the volume
vw : Decreases the volume
Rear Level (REAR LEVEL a/ VW )}
Adjust the rear speaker volume.
& : Increases the volume
vw © Decreases the volume
Delay Time (DELAY TIME)
Use this button to select the delay time.
Muting Button (AUDIO MUTING)
Press to activate muting and cut off the sound. Press again to
deactivate the muting and return to original volume level.
Switching off power to the unit also deactivates the muting.
Volume Control (VOLUME 4 / Ww )
Adjust volume level
A | increases the volume
v : Decreases the volume