Onkyo ES-600PRO

Using the remote control transmitter
aaa
@® For details on the function of each control, see the description
in “Remote Control Transmitter” (RC-199M) on page 7.
® Batteries
The remote control transmitter is powered by two batteries.
Before using this unit for the first time, insert the two batteries
(included) as shown in the diagram The remote contro! trans-
mitter has no on/otf switch. Average battery life is one year.
This period may be shorter depending on the frequency of use
and environment (temperature and humidity) in which the re-
mote control transmitter is used. If the remote contro! transmitter
does not operate even though front panel controls function
normally, the batteries should be replaced. Use only batteries
listed in the following chart.
AA
1.5V R6
Manga-
nese
Do not leave an exptred battery in the case as it may leak
or damage the battery case.
When inserting the batteries. be sure the (+) and (-)} ends
are properly aligned.
Do not use nickel-cadmium (rechargeable) batteries.
Do not use one specified (manganese) battery and one al!-
kaline battery at the same time.
Replace both batteries at once; do not use one old and one
new battery together.
Transmitter Battery Replacement
ES-600PRO
Remote sensor
a approx. Sm
j LS (16 feet)
Remote controt transmitter
RC-199M
Precautions
Remove the batteries if the remote control transmitter is not going
to be used for a jong time.
The batteries of the remote control transmitter must be replaced
periodically. Remember, however, that commands will be re-
ceived only when the main power switch of the ES-600PRO
Is On.
This unit uses infrared rays. Therefore. commands may not be
received properly !f the front panel of the ES-600PRO ts exposed
to bright light. To prevent this from occurring, place the
ES-600PRO so that it Is not directly exposed to a bright light.
If the ES-600PRO is piaced tnside an audio rack behind a glass
door, the door should not use colored glass or have any deco-
rations on !t since this could shorten the range or prevent
commands from being received.
Use of other infrared remote control devices in the same room
may cause Interference.
(He rravisnitter operates Uo to @a Wstatice Of about ve rrerers
(16 feet}. The transmitting window must always be pointed at
the reception window when a command is sent to the
ES-600PRO.
If this remote contral transmitter does not operate properly,
confirm that the batteries are not dead. If the problem persists,
contact your ONKYO service center.