20
Playing USB Memory
The unit supports USB memory formatted
using FAT12, FAT16 and FAT32 file system.
The unit is compatible with MP3
playback and following audio format is
supported.
- MPEG1 Audio Layer3 format with a
sampling rate of 32, 44.1 or 48 kHz and
32 to 320 kbps bit rate
- MPEG2 Audio Layer3 format with a
sampling rate of 16, 22.05 or 24 kHz
and 8 to 160 kbps bit rate
- MPEG2.5 Audio Layer3 format with a
sampling rate of 8, 11.025 or 12 kHz
and 8 to 64 kbps bit rate
You can play MP3 files stored on the
root folder only. MP3 files stored on
the other folders cannot be played on
this unit.
The unit supports USB flash drives only.
Note, however, that playback may not
be possible with some USB flash drives.
The unit contains a microcomputer
for signal processing and control
functions. In very rare situations,
severe interference, noise from an
external source, or static electricity
may cause it to lockup. In the unlikely
event that this happens, unplug the
power cord from the wall outlet, wait
at least five seconds, and then plug
it back in.
If it doesn’t work properly, please try
resetting (oP.18).
Onkyo is not responsible for damages
(such as CD rental fees) due to
unsuccessful recordings caused by
the unit’s malfunction. Before you
record important data, make sure
that the material will be recorded
correctly.
To Next Page
Loading...
