Onkyo LS3100 User Manual

21
En
Useful Function
Programming the controller for use of
existing remote controller
The controller can be operated with your existing TV remote controller or any other remote
controller by programming the controller. This section explains how to program the controller to
operate ON/STANDBY function on the controller by pressing the 5 (number button) on your TV
remote controller as an example.
This operation can be done only from the top panel.
The following button operation can be set.
On/Standby
Volume –/+
Mute
Bluetooth
Sound Mode
Here is an example of operating the
8ON/STANDBY button function of the
controller by pressing the 5 (number button) on
your TV remote controller.
■ Button operation
Note
• Operating one button operation on the controller by
several other remote controllers is not possible.
• If you use the remote controller programming
function, TV remote controller preprogrammed
code registered in the controller cannot be used
(➔ page 10). If you operate the controller with
your TV remote controller by using TV remote
controller preprogrammed code, the controller
should be initialized (➔ page 22).
Settable button operation
Setting the button operation
1
Simultaneously press and hold the
/TV input button and
8ON/STANDBY for three seconds.
The mode is switched to the remote
controller programming mode and
ON/STANDBY LED flashes amber.
2
Aim your TV remote controller to the
remote control sensor of the controller
and press 5 (number button) on your TV
remote controller three times within
10 seconds.
The ON/STANDBY LED flashes amber
twice indicating that the registration is
completed.
Tip
•If the ON/STANDBY LED does not flash by
pressing the buttons on your TV remote
controller, your TV remote controller might be
the type that the controller cannot read. In this
case, use the supplied remote controller.
Operating
function
Button operation on the
controller
8ON/STANDBY
+ 8ON/STANDBY
Volume +
+ Volume +
Volume –
+ Volume –
Mute
+ Volume + + Volume –
/TV input + 8ON/STANDBY +
Volume +
Sound Mode
+ 8ON/STANDBY +
Volume –

Onkyo LS3100 Specifications

General

Product color	Black
RMS rated power	- W
Recommended usage	Home theatre
Remotely operated	Yes
Audio output channels	2.1 channels
Amplifier frequency range	50 - 20000 Hz
Signal-to-Noise Ratio (SNR)	93 dB
Total Harmonic Distortion (THD)	0.8 %
Amplifier dimensions (W x D x H)	187 x 120 x 32 mm
Satellite speaker type	2-way
Satellite speaker weight	700 g
Number of satellite speakers	2
Satellite speakers RMS power	40 W
Satellite speaker frequency range	200 - 20000 Hz
Satellite speaker dimensions (WxDxH)	169 x 108 x 78 mm
Subwoofer type	Active subwoofer
Subwoofer weight	5800 g
Subwoofer frequency range	40 - 200000 Hz
Subwoofer drivers quantity	1
Subwoofer dimensions (WxDxH)	261 x 269 x 337 mm
Subwoofer driver diameter (imperial)	6.3 \
Power source	AC
AC input voltage	230 V
AC input frequency	50 Hz
Bluetooth version	2.1+EDR

Weight and Dimensions

Set weight	10500 g