21
Recording to an MD
5. Using the REC LEVEL knob, adjust
the recording level.
Adjust the position of the REC LEVEL
knob so that the indicator occasionally
enters the -6 to -2 range.
When adjustment of the recording level
is complete, stop playing the source.
6. With the unit in recording standby
mode, press the INPUT button to
display the current Level Sync status
(LvlSyncOn or LvlSyncOff).
You can change the Level Sync ststus
by pressing the INPUT button again.
With "LvlSyncOn", the track number
will be recorded automatically for each
track.
• Pressing the INPUT button in other
than the recording or recording standby
mode changes the input source you set
in step 3.
• Since interval between tracks is
detected from the sound level, tracks to
be recorded may not continue in the
correct sequence in the following cases:
• Recorded condition of the cassette
tape is bad. (noise between tracks)
• Low level sound continues, in classic
music, etc.
• Interval between tracks is extremely
short.
• Reception condition of tuner is bad
(noise, etc.).
Note:
To Manually Record a Track Number
While recording, press the
∂ REC
button when you wish to mark a track
number.
If you wish to mark two or more track
numbers sequentially, provide a
sufficient interval between each press
of the
∂ REC button. Too short (about
4 seconds or less) an interval may lead
to a failure in marking track numbers.
7. Press the
ø button to start record-
ing and then start playing the
recording source immediately.
The TOC indicator appears as soon as
the recording starts.
The MD recorder will automatically
stop when recordable time of the disc
being recorded runs out.
To stop recording temporarily...
Press the
øø
øø
ø
button (or the
ƒƒ
ƒƒ
ƒ
button on
the remote controller). To resume record-
ing, press the
øø
øø
ø
button again (or press the
¬¬
¬¬
¬
button on the remote controller).
To stop recording...
Press the
ß button.
To eject the MD...
Press the
ß button and then the å
button.
5
7
6
Note:
If TOC is flashing when you press the
å button or the STAND-BY/ON button, it
means the MD recorder is writing the recorded contents onto the MD. During this
period, do not disconnect the power cord or apply strong vibrations to the MD recorder.
Doing so may prevent normal recording onto the MD.
If the MD recorder's power cord is connected to the SWITCHED service power outlet
on the rear panel of your amplifier, etc., do not turn off the amplifier.
INPUT
12345
678910
11 12 13 14 15
010 22040
R
6
L
15
ANALOG IN
12345
678910
11 12 13 14 15
010 22040
R
6
L
15
ANALOG IN
ANALOG IN
TRACK
010 22040
R
6
L
TOC 15
12345
678910
11 12 13 14 15
TRACK
12345
678910
11 12 13 14 15
010 22040
R
6
L
15
ANALOG IN
REC LEVEL
MIN MAX
-6〜-2
LEVEL-SYNC automatically updates a track at any rise of input level.
To Next Page
Loading...
Need help?
General
