EasyManuals Logo

Onkyo NCP-302 Wi-Fi Set-Up Guide

Onkyo NCP-302
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Step 8: Change the NCP-302's input to the Wi-Fi symbol by pressing the Input button on the top of the
NCP-302. Please do not press and hold the “Input” button. Simply tap the “Input” button once in order
for the input light to indicate a change.
Step 9: Connect the supplied audio cable from the headphone jack on your phone/tablet to the “Aux
In” port located on the back of the Onkyo NCP-302. Please maximize the volume on your phone/tablet
for only the duration of this setup. Please tap the “Next” button. (Shown below).

Other manuals for Onkyo NCP-302

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo NCP-302 and is the answer not in the manual?

Onkyo NCP-302 Specifications

General IconGeneral
Product colorBlack
Volume controlRotary
Recommended usageUniversal
Multi-Room Streaming (MRS) supportYes
Speaker type2-way
Woofer diameter77 mm
Tweeter diameter26 mm
Number of drivers-
Speaker placementTabletop/bookshelf
Audio output channels- channels
RMS rated power- W
Signal-to-Noise Ratio (SNR)75 dB
Total Harmonic Distortion (THD)0.5 %
Package depth206 mm
Package width426 mm
Package height262 mm
Package volume3800 cm³
Connectivity technologyWired & Wireless
Cables includedAC, AUX
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.5 W
Power consumption (typical)10 W
Weight and Dimensions IconWeight and Dimensions
Depth106 mm
Width320 mm
Height172 mm
Weight2600 g

Related product manuals