Onkyo NCP-302 Wi-Fi Set-Up Guide

Step 14: Tap the Update icon (Shown below), the Onkyo Controller application will begin the update
process. It is very important to not close the Onkyo Controller application or turn off the Onkyo NCP-
302 during this process. The time the update takes to complete is dependent on download size,
download speed, and network traffic. The Onkyo Controller application will display, “The latest
software has been installed on your device”, when complete.
Step 15: When the firmware update is complete, the Onkyo Controller application will state, “The
latest software has been installed on your device. Tap the “OK” button. (Shown below).

Onkyo NCP-302 Specifications

General

Product color	Black
Volume control	Rotary
Recommended usage	Universal
Multi-Room Streaming (MRS) support	Yes
Speaker type	2-way
Woofer diameter	77 mm
Tweeter diameter	26 mm
Number of drivers	-
Speaker placement	Tabletop/bookshelf
Audio output channels	- channels
RMS rated power	- W
Signal-to-Noise Ratio (SNR)	75 dB
Total Harmonic Distortion (THD)	0.5 %
Package depth	206 mm
Package width	426 mm
Package height	262 mm
Package volume	3800 cm³
Connectivity technology	Wired & Wireless
Cables included	AC, AUX
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	10 W

Weight and Dimensions

Depth	106 mm
Width	320 mm
Height	172 mm
Weight	2600 g