110
Advanced Setup—Continued
Network
See “Network Settings” on page 121.
Firmware Update
Notes:
• Perform the firmware update only when an announcement is posted on the Onkyo Web site.
• It takes about 60 minutes to complete the firmware update.
• When updating a firmware from a USB mass storage device, the AV controller searches the device which is con-
nected earlier during power on. If two devices have been connected at the time of power on, the AV controller will
search the device on the front panel.
Version
The current version of the firmware is displayed. The version is made up of the versions of the AV controller
and Onkyo dock (if connected).
Receiver via NET: You can update the firmware via Internet. Check the network connection
before update.
via USB: You can update the firmware from a USB mass storage device.
You can update the AV controller’s firmware. Do not shutdown the power of the AV controller while update.
Universal Port via NET: You can update the firmware via Internet. Check the network connection
before update.
via USB: You can update the firmware from a USB mass storage device.
You can update the Onkyo dock’s firmware. Do not shutdown the power of the AV controller while update.
Note:
This update shall not be performed when no dock is connected to UNIVERSAL PORT jack.
To Next Page
Loading...
Need help?
General
