Onkyo SBT-A500 User Manual

44
> Before Start > Part Names > Install > Initial Setup > Playback
Advanced Setup | Firmware Update | Others
E
N
■ 2. Level Calibration ■ 3. Dolby Enabled Speaker
Front Left Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Center Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Front Right Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Height Left Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Height Right Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Subwoofer Select a value between "j15 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Dolby Enabled
Speaker to Ceiling
Set the distance between the sound bar and the ceiling. Select
between "0.1ft/0.03m" to "15.0ft/4.50m" (0.1ft/0.03m units).
(Default Value is "6.0ft")
0 Distance units (feet/meters) can be switched by pressing
MODE on the remote controller.
AccuReflex You can enhance the reflection effect from the ceiling.
"On (Default Value)": Use this function
"Off": Do not use this function

Onkyo SBT-A500 Specifications

General

Brand	Onkyo
Model	SBT-A500
Category	Speaker System
Language	English