Onkyo TX-866 - Page 4

Precautions
ne
1. Warranty Card
The serial number is written on the rear panel of this unit. Copy
the sertal number and model number onto your warranty card
and keep it in a safe place.
2. Recording Copyright
Recording of copyrighted material for other than personai use
is illegal without permission of the copyright holder.
3. AC Fuse
The fuse is located inside the chassis and is not user serviceable.
lf power does not come on, contact your Onkyo service center.
4. Care
From time to time you should wipe off the front and rear panels
and the cabinet with a soft cloth. For heavier dirt, dampen a soft
cloth in a weak solution of mild detergent and water or a mild
ammonia cleaner, wring it out dry, and wipe off the dirt. Fol-
lowing this, dry immediately with a clean cloth. Do not use rough
material, thinners, alcoho! or other chemical solvents or cloths
since these could damage the finish or remove the panel fettering.
Before using this unit
1. Supplied Accessories
AM loop T-shaped FM
antenna x 1 antenna X 1
2. Transmitter Battery Insertion
Precautions when using batteries
@ The remote control transmitter is powered by two batteries.
Before using this unit for the first time, insert the two batteries
(included) as shown in the diagram.
@® Average battery life is about one year. This period may be shorter
depending on the frequency of use and environment (temper-
ature and humidity) in which the remote contro! transmitter is
used.
Memory Preservation
This unit does not require memory preservation batteries. A
built-in memory power back-up system preserves the contents
of the memory during power failures and even when the unit
is unplugged. The unit must be plugged in and the power switch
turned on and off once tn order to charge the back-up system.
Note that since this is not a permanent memory, the power switch
must be turned on and off a few times each month to keep the
back-up system operative.
The memory preservation period after power has been turned
off varies depending on climate and placement of the unit. On
the average, memory contents are protected over a period of a
few weeks after the last time power has been turned off. This
period is shorter when the unit is exposed to a highly humid
climate.
anf poe,
fRi remote contro! cable x 1 Remote control transmitter x 1
Batteries x 2
If the remote control transmitter does not operate even though
front panei controls function normally, the batteries should be
replaced. Use only batteries listed in the following chart.
Manga- AA
in, 1.5V R6
UM-3
Do not leave an expired battery in the case as it may leak
or damage the battery case.
When inserting the batteries, be sure the (+) and (—) ends
are properly aligned.
Do not use nickel-cadmium (rechargeable) batteries.
Do not use one specified (manganese) battery and one al-
kaline Battery at the same time.
Replace both batteries at once; do not use one old and one
new battery together.