Onkyo TX-RZ610

11
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
■ 3� Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value Setting Details
Front Left 12.0ft Specify the distance between each speaker and
the listening position.
Center 12.0ft Specify the distance between each speaker and
the listening position.
Front Right 12.0ft Specify the distance between each speaker and
the listening position.
Height Left (9.0ft) Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set in
"Configuration" - "Zone Speaker" and Zone 2 is on.
Height Right (9.0ft) Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set in
"Configuration" - "Zone Speaker" and Zone 2 is on.
Surround Right 7.0ft Specify the distance between each speaker and
the listening position.
Surr Back Right 7.0ft Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set in
"Configuration" - "Zone Speaker" and Zone 2 is on.
Surr Back Left 7.0ft Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set in
"Configuration" - "Zone Speaker" and Zone 2 is on.
Surround Left 7.0ft Specify the distance between each speaker and
the listening position.
Subwoofer 12.0ft Specify the distance between each speaker and
the listening position.
•
Distance units can be switched by pressing MODE on the remote controller. When the unit is set as
feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1ft. When the unit is set as meters, you
can set between 0.03 m and 9.00 m in increments of 0.03 m.
■ 4� Level Calibration
Setting Item Default Value Setting Details
Front Left 0 dB Select a value between "－12 dB" and "＋12 dB"
(in 1 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Center 0 dB Select a value between "－12 dB" and "＋12 dB"
(in 1 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Front Right 0 dB Select a value between "－12 dB" and "＋12 dB"
(in 1 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Height Left (0 dB) Select a value between "－12 dB" and "＋12 dB"
(in 1 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
•
The setting cannot be changed if "Zone 2" is set
in "Configuration" - "Zone Speaker" and Zone 2
is on.
Height Right (0 dB) Select a value between "－12 dB" and "＋12 dB"
(in 1 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
•
The setting cannot be changed if "Zone 2" is set
in "Configuration" - "Zone Speaker" and Zone 2
is on.
Surround Right 0 dB Select a value between "－12 dB" and "＋12 dB"
(in 1 dB increments). A test tone will be output
each time you change the value. Select the desired
level.