Onlogic ML100G-51 - Safety and Compliance; Regulatory Compliance and Safety Information; Safe Use and Installation Instructions

ML100G-51/52 Industrial Computer
4
Regulatory Compliance and Safety Information
Regardingequipment:IndustrialFanlessPCmodel(s):xxxxxML100G-51xxxxxandxxxxxML100G-52xxxxx
(wherexisanyalphanumericcharacter,“-”orblankdesignatingcongurationdierences)
Safe Use and Installation Instructions
1. Donotopenormodifythedevice.ThedeviceusescomponentsthatcomplywithFCCandCE
regulations.Modicationofthedevicemayvoidthesecertications.
2. Install the device securely. Be careful handling the device to prevent injury and do not drop.
3. Wallorceilingmountingdevicerequiresuseofamountingplateorbracket.Plateorbracketmustbeof
metalconstructionandhaveaminimumthicknessof1mm.
4. UseM3x0.5mmFlatHeadscrewstoattachmountingplateormountingbracketstothreadedholeson
bottom or rear of chassis. Screws should be minimum length of 4mm. Add 1mm of screw length for
everymilimeterofadditionalthicknessofplateorbracketbeyond1.5mm.
5. Ambientoperationaltemperaturemustbebetween0°Cto40°C,orwithsomecongurations
0°Cto50°C,withanon-condensingrelativehumidityof10-90%.
6. Thedevicecanbestoredattemperaturesbetween-40°Cto85°C.
7. Keepthedeviceawayfromliquidsandammablematerials.
8. Donotcleanthedevicewithliquids.Thechassiscanbecleanedwithacloth.
9. Allow at least 2 inches of space around all sides of the device for proper cooling. If device is mounted
toverticalsurfacethenrecommendeddeviceorientationsothatheatsinknsallowairtorise
unobstructed. Alternative orientations may result in reduced operational temperature range.
10. Thisdeviceisintendedforindooroperationonly.
11. UseULListedexternalpowersupplywithratedoutput12Vd.c.,5Amin.
12. Installthedeviceonlywithshieldednetworkcables.
13. Serviceandrepairofthedevicemustbedonebyqualiedservicepersonnel.Thisincludes,butisnot
limitedto,replacementoftheCMOSbattery.ReplacementCMOSbatterymustbeofthesametypeas
original.
14. Proper disposal of CMOS battery must comply with local governance.
Revision History
Revision History Date
Release of ML100G-51/52 manual 7/31/2019