onsenproducts.com
onsenproducts.ca
800-996-5559
support@onsenproducts.com
ENGLISH
8
CONNECTING THE LP TANK
The knob on the LP tank must be closed.
Make sure that the knob is turned clockwise
to a full stop. The cylinder supply system must
be arranged for vapor withdrawal.
Check that the ON/OFF button located at the bottom
of the water heater is in the OFF position.
Remove the protective cap from the LP tank valve and coupling nut.
Hold the regulator in one hand and insert the nipple into the valve
outlet. Be sure the nipple is centered in the valve outlet. The cou-
pling nut connects to the large outside threads on the valve outlet.
Use care – do not cross thread the connection.
Hand tighten the coupling nut clockwise until it comes to a full
stop. Firmly tighten by hand only. Do not use tools.
To disconnect: Fully close the tank valve by turning clockwise .
Turn the coupling nut counter-clockwise until the regulator
assembly detaches.
1
2
3
4
5
Connect 20 lb LP gas tank:
Connect the gas regulator hose (Fig. 2) to a 20 lb LP gas tank. DO
NOT OPEN THE TANK’S GAS VALVE YET.
To Next Page
Loading...
