What to do if Ontech GSM 9040 unit does not respond to commands?
If your Ontech Accessories unit isn't responding to commands, verify that the correct password is set and that the mobile number is accurate. A wrong password or incorrect mobile number can prevent the unit from responding.
How to fix Ontech Accessories unit when it cannot connect to extra units?
If your Ontech Accessories unit can't connect to extra units like the Ontech Relay and Ontech Alarm box, ensure that all units in the system have the same radio channel set. Also, check that the short-range radio function is turned on. These settings can prevent connection issues.
What to do if Ontech Accessories unit does not return status request?
If the Ontech Accessories unit does not return status requests, the prepaid card may have insufficient funds. Refill the prepaid SIM card to resolve this issue.
Why are both lamps blinking on my Ontech GSM 9040 Accessories unit?
If both lamps are blinking when the Ontech Accessories unit is connected to the main power, it indicates that the unit cannot read the SIM card. This could be due to several reasons: the SIM card is missing, PIN code protection is enabled on the SIM card, or a welcome message from the network operator is active on the SIM card. To resolve this, disable the welcome message by making a brief call with the card in a telephone.
What to do if Ontech GSM 9040 Accessories sends alarm messages when sensors are not activated?
If your Ontech Accessories unit sends alarm messages even when the alarm sensors are not activated, it might be because one alarm input is open in Normally Closed mode. If Normally Closed is set and only one alarm input is used, the other has to be connected to the 3.8 V.
Insert SIM card and create an account on the official website for initial setup.
Information on where to find help and support for the product.
Instructions for connecting extra units like Rtelay 9015 or Alarm Box to the system.
Steps to connect and configure an external temperature sensor for monitoring.
Guide for connecting the IR 9016 unit to control air conditioners or heat pumps.
Instructions for connecting wired alarm sensors and configuring them in the control panel.
Formal statement declaring the product's compliance with relevant EU directives.
Network| GSM frequency bands | Dual band GSM 900/1800 MHz |
|---|---|
| Short range radio frequency | 2.4 GHz |
| Short range radio power | 1 mW |
Power| relay voltage | 230 V |
|---|---|
| relay current | 16 A |
| power consumption (idle) | <0.5 W |
| power consumption (maximum) | 4 W |
Battery| backup battery voltage | 4.2 V |
|---|---|
| backup battery capacity | 1100 mA |
Operating Environment| temperature operating range | -40°C to +45°C |
|---|---|
| internal temperature sensor tolerance | +/- 2°C |
| external temperature sensor tolerance | +/- 1°C |
To Next Page
