Onyx DX26 - User Manual

Questions and Answers

B
Brian OsbornJul 25, 2025
What to do if the Onyx DX26 recovery rate is low?
- A
  Alicia CoxJul 25, 2025
  If you notice a low recovery rate with your Onyx Floor Machine, here are a few things to check: * First, drain the recovery tank if it's full. * Second, inspect and clean the recovery suction pipe if it's blocked. * Third, examine the recovery tank seal for damage and replace it if needed.
E
Elijah BrownJul 30, 2025
Why is my Onyx DX26 Floor Machine not working?
- S
  Stephanie JamesJul 30, 2025
  If your Onyx Floor Machine isn't operating, several factors could be at play: * The battery might be completely discharged; try charging it. * The battery itself might be faulty, requiring a replacement. * Loose battery wiring can also prevent operation, so ensure it's securely fastened. * Lastly, a blown main fuse could be the culprit; in that case, replace the fuse.
D
David LoweryAug 4, 2025
What to do if the vacuum motor doesn’t work on my Onyx Floor Machine?
- M
  Mr. Gene FreemanAug 4, 2025
  If the vacuum motor on your Onyx Floor Machine isn’t working, consider these potential causes: * Ensure the squeegee is properly lowered to the ground. * Check the vacuum motor fuse and replace it if it's blown.
J
jocelynchambersAug 9, 2025
Why is the operating time so short on my Onyx DX26?
- V
  Virginia WoodAug 9, 2025
  If your Onyx Floor Machine has a short operating time, the cause may be a damaged battery, which should be replaced. Alternatively, the charger may be faulty and need replacement.
I
ileeAug 14, 2025
What to do if little or no water flows out of my Onyx DX26?
- L
  Leah GarciaAug 14, 2025
  If little to no water flows from your Onyx Floor Machine, try the following: 1. Clean out the solution filter if the filter or solution hose is clogged. 2. Adjust the water control knob if the speed of the flow knob is off. 3. Lubricate and fasten the screw if the screw of the water knob is loose.
N
nyoungAug 19, 2025
How to fix a brush motor that doesn't work on an Onyx DX26?
- M
  michael88Aug 20, 2025
  If the brush motor on your Onyx Floor Machine isn't working, you can try the following: * Lower the brush head if it is off the ground. * Charge the battery if the battery meter is locked.