Chapter 2 Hardware Installation 2-7
the power source to avoid damage by transient over-voltage.
14. Never pour any liquid into an opening. This could cause fire or
electrical shock.
15. Never open the equipment. For safety reasons, only qualified
Service personnel should open the equipment.
16. If any of the following situations arises, get the equipment
checked by service personnel:
a. The power cord or plug is damaged.
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well, or you cannot
get it to work according to the user manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
17. DO NOT LEAVE THIS EQUIPMENT IN AN UNCONTROLLED
ENVIRONMENT WHERE THE STORAGE TEMPERATURE IS
BELOW -20° C (-4°F) OR ABOVE 60° C (140° F). IT MAY
DAMAGE THE EQUIPMENT.
18. External equipment intended for connection to signal
input/output or other connectors, shall comply with
relevant UL / IEC standard (e.g. UL 1950 for IT equipment
and ANSI/AAMI ES 60601-1: 2005 AND CAN/CSA-C22.2
No. 60601-1:08 / IEC 60601 series for systems – shall
comply with the standard IEC 60601-1-1, Safety
requirements for medical electrical systems. Equipment
not complying with UL 60601-1 shall be kept outside the
patient environment, as defined in the standard. Any
To Next Page
Loading...
Need help?
General
