Vehicle care 141
Bulb replacement
Switch off the ignition and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base! Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check
After a bulb replacement, switch on
the ignition, operate and check the
lights.
Halogen headlights
Headlights have separate systems for
low beam/sidelight 1 (outer bulb),
high beam/daytime running light 2
(inner bulb).
To access bulbs, pull off protective
covers.
Low beam
1. Remove protective cover.
2. Detach connector from bulb.
3. Disengage wire clip and remove
bulb from reflector.
4. Insert new bulb in reflector so that
the locating tab of the bulb aligns
with the reflector recess.
5. Attach connector to bulb.
6. Engage wire clip.
7. Install protective cover.
High beam
1. Remove protective cover.
2. Detach connector from bulb.
3. Disengage wire clip and remove
bulb from reflector.
To Next Page
Loading...
