144 Vehicle care
Brake light (1)
Turn signal light (2)
Tail light (3)
Tail light/fog light (4)
7. Install seal on bulb holder
ensuring it is fitted correctly.
Install bulb holder in light housing
ensuring that it engages correctly.
Tighten the four retaining screws
using a screwdriver.
8. Install reverse light bulb holder
and turn clockwise to tighten.
9. Engage connector plug.
10. Insert light housing in body,
ensuring correct positioning.
Tighten the three retaining
screws.
11. Switch on ignition, operate and
check all lights.
Side turn signal lights
Have bulbs replaced by a workshop.
Centre high-mounted brake
light
Have bulbs replaced by a workshop.
Number plate light
Tailgate
1. Insert screwdriver as indicated by
the arrows, press to the side and
release the bulb housing.
To Next Page
Loading...
