139Lighting
Picture no: 18445t.tif
Main beam, headlamp flash
To switch from dipped beam to main
beam, press stalk forwards.
To switch back to dipped beam, press stalk
forwards again or pull towards steering
wheel.
To activate the headlamp flash, pull stalk
towards steering wheel. Main beam is
engaged for the duration of activation.
Picture no: 17123t.tif
Automatic dipped beam
activation 3
Light switch set to AUTO: When the engine
is running, dipped beam is activated if
exterior light conditions call for such.
For reasons of safety, the light switch should
always remain in the AUTO position.
Move light switch to 9 if visibility is poor
because of fog, for example.
Picture no: 16989t.tif
Turn signal lamps
To activate, press stalk up or down lightly.
Stalk up = Right turn signal lamps
Stalk down = Left turn signal lamps
To Next Page
