31
Wiper blade replacement
Caution
● Take care not to hold the arms
at the jet locations.
● Do not release them while
moving them. Risk of damaging
the windscreen.
1. Grasp the wiper blade by its rigid
part and pull it towards you as far
as it will go.
2. While keeping the wiper arm
raised, unclip the worn blade (1)
and remove it (2).
3. While keeping the wiper arm
raised, install the new blade and
clip it into place.
4. Lower the arm carefully and
support it until it reaches the
windscreen.
Bulb replacement
All lights are designed as LEDs and
cannot be changed.
Have lights repaired by a workshop in
case of failure.
Fuses
Data on the replacement fuse must
match the data on the defective fuse.
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by its
melted wire.
Caution
Do not replace the fuse until the
cause of the fault has been
remedied.
The fuse boxes are located behind
the seats.
Turn both fixing screws a quarter turn
and remove the access cover.
To Next Page
Loading...
