What to do if the service light is on but OpeMed OT200 Medical Equipment works OK?
If the service light (red spanner) is on but the hoist works OK, it indicates that the OT200 medical equipment should be serviced and LOLER inspected every 6 months as per LOLER & ISO10535. Contact OpeMed for a service at 01252 758858.
What to do if charging light is flashing and OpeMed Medical Equipment is slow?
If the charging light is flashing and the hoist is slow to use, return the OpeMed medical equipment hoist to the charging station and leave it for a minimum of 2 hours.
What to do if the OpeMed Medical Equipment hoist is not working and the yellow light is flashing?
If your OpeMed Medical Equipment hoist isn't working, and you see a green light momentarily followed by a flashing yellow light, try these steps: First, ensure the hoist is correctly parked on the charging point. Next, check that the handset plug is fully inserted. Finally, verify that the charger is switched on at the mains and that the green light indicates it is receiving power.
General| Category | Medical Equipment |
|---|---|
| Product Type | Oxygen Concentrator |
| Operation | Continuous Flow |
| Oxygen Purity | 93% ± 3% |
| Noise Level | ≤ 45 dB(A) |
| Operating Temperature | 10°C to 40°C |
To Next Page
