Opis 60s - Page 8

8
⇒ if the mode was set successfully the phone rings once.
⓳② Only naonal numbers and no emergency calls
This mode only allows the use of naonal phone numbers. The emergency numbers
112, 110 and 911 are not allowed. Short dials as set in ❾ only work if they are na-
onal numbers. To enable this mode, pick up the receiver and dial:
Format: *00#2#<PIN>*
Example: to enable mode 2 and set the 4-digit PIN to 1234: *00#2#1234*
⇒ if the mode was set successfully the phone rings once.
⓳③ Immediate dial of one number on pick-up
This mode automacally dials the quick-dial programmed as *1 (see ❾ ) as soon as
the receiver is picked up. All dial inputs are ignored. Incoming calls can sll be an-
swered by picking up the receiver when the phone rings. To enable this mode, pick up
the receiver and dial:
Format: *00#3#<PIN>*
Example: to enable mode 3 and set the 4-digit PIN to 1234: *00#2#1234*
⇒ if the mode was set successfully the phone rings once.
⓳⓪ Disabling special modes
The special modes ⓳① and ⓳② can be disabled at any me by picking up the
receiver and dialling:
Format: *00#0#<PIN>*
Example: if your chosen PIN was 1234: *00#0#1234*
⇒ if special modes were disabled and normal operaon is again ac-
ve the phone rings once.
IMPORTANT: Special mode ⓳③ cannot be disabled this easily, because picking up
the receiver will always lead to dialling short dial *1. To end this mode, please switch
o the telephone. For the 60s mobile 4G then rotate the dial disc to the 1 posion and
hold it there, for the PushMeFon mobile 4G press and hold both # and *. Now switch
on the telephone (sll holding the dial disc or pressing the buons) and wait for about
30 seconds. Now you can disable this special mode in the same way as described for
⓳① and ⓳② above.
List of all commands
Command Example Funcon
*01#<local area code>* *01#01234* Enter/Change a local area code