Optima OPF-P Series - Page 11

OPF-P Series
User Manual / Using Scale
1
11/13
•
Zero Tracking Range
•
Values from 0 to 6
•
Factory default is 5
•
Enter the user setting mode, and press M+ until you see “ZTRC?”.
•
Press ZERO or TARE key to select the zero tracking value.
•
Press M+ key to confirm the revised value or press the UNIT WEIGHT key to
cancel the changes.
•
Zero Display Range
•
Values from 0 to 6
•
Doesn’t affect the zero value, but just the display
•
Factory default is 3.
•
Enter the user setting mode, and press M+ until you see “ZDSP?”.
•
Press ZERO or TARE key to select the zero display value.
•
Press M+ key to confirm the revised value or press the UNIT WEIGHT key to
cancel the changes.
•
Power On Unit
•
Units selectable from kg, g, lbs, and oz.
•
Enter the user setting mode, and press M+ until you see “UNIT?”.
•
Press ZERO or TARE key to select the unit.
•
Press M+ key to confirm the revised value or press the UNIT WEIGHT key to
cancel the changes.
•
Backlight
•
Selectable between ON, OFF or AUTO (factory default).
•
Enter the user setting mode, and press M+ until you see “BLIG?”.
•
Press ZERO or TARE key to select the value
•
Press M+ key to confirm the revised value or press the UNIT WEIGHT key to
cancel the changes.
•
Auto Calibration
•
Selectable between ON or OFF (factory default)
•
Enter the user setting mode, and press M+ until you see “ACAL?”.
•
Press ZERO or TARE key to select the value
•
Press M+ key to confirm the revised value or press the UNIT WEIGHT key to
cancel the changes.
•
PLU Function
•
Selectable between ON (factory default) or OFF
•
Enter the user setting mode, and press M+ until you see “PLU?”.
•
Press ZERO or TARE key to select the value
•
Press M+ key to confirm the revised value or press the UNIT WEIGHT key to
cancel the changes.