Optimum 9400 - Getting to Know Your Optimum 9400; Using Your Optimum 9400

4 5
On/O Switch
The main power switch of the machine, please note that unless this switch is in the “ON” position, the
blender will not function at all.
Speed dial
The speed dial controls the speed of the blades (RPM) and the power delivered to the jug contents,
a detailed explanation of the use of this dial can be found on page 9.
Pulse Switch
As a safety precaution, the blender will not allow the pulse switch to operate without the main switch
being in the “ON” position. This is due to the very high RPM the Pulse button is able to achieve, this
is to improve stability of the machine and the attached jug and increase the safety of the machine to
comply to safety standards.
Tamper Tool
Allows you to push thick contents inside the jug, down onto the blade assembly to be thoroughly
chopped. Please read the guide on page 7 to use the tamper eectively.
Jug Lid
Use caution when attaching the lid to the jug, you must ensure that the lid rim is clipped in under the
tabs on each side of the jug opening, ensuring the lid will not come o during the blending process.
For your own safety (and retaining a clean kitchen) ensure the lid is firmly attached before you
proceed in blending.
GETTING TO KNOW YOUR OPTIMUM 9400 USING YOUR OPTIMUM 9400 - BASIC OPERATION
1. Lid plug
2. Lid
3. Jug
4. Blade assembly
5. Cushion pad
6. On/O switch
7. Pulse switch
8. Tamper
9. Speed dial
DONOTFILLJUGABOVETHELIMITMARK.