OPTIMUM
MASCHINEN - GERMANY
Assembly and maintenance instruction recirculating ball screw
5. Dezember 2007 Page 19Recirculating ball screw assembly and maintenance instruction ; Version 2.0
© 2007
GB
£ Drag the slide out of the guideways.
Fig.1-40: Drag out the slide (Z-axis)
£ Drag the fixture out of the spindle
nut.
Fig.1-41: Drag off fixture
£ Remove the spindle with the pillow
block from the Z-axis.
Fig.1-42: Remove spindle
£ Drag the expansion bellows out of
the guideway of the Z-axis.
Fig.1-43: Drag off expansion bellows
Slide Z-axis
Spindle nut
Fixture
Pillow block
Spindle
Expansion bellows
To Next Page
Loading...