To Next PageTo Next PageWhy does my Optoma EP1080 Projector have no power?
If your Optoma Projector isn't turning on, make sure the power cord and AC power outlet are securely connected. Also, check the lamp cover and interrupt switch. Ensure all connectors are securely connected and aren’t broken. You may need to check the Lamp Driver, LVPS, Scaler Board, or Formatter Board.
What causes image flicker on my Optoma EP1080 Projector?
Image flicker on your Optoma Projector can be resolved by doing a “Reset (All data)” of the OSD Menu. Also, ensure that the signal cables and source are working correctly. If not, check the Lamp Module, Color Wheel, DMD Board, Scaler Board, and Formatter Board.
What to do if my Optoma EP1080 Projector has no image?
If your Optoma Projector is not displaying an image, ensure the signal cable and source are working. If multiple sources are connected, use the “Source” button to switch between them. Also, ensure all connectors are securely connected and aren’t broken. You may need to check the Scaler Board, Formatter Board, DMD Board, DMD Chip, or Engine Module.
Why does my Optoma EP1080 display a garbage image?
If your Optoma Projector is showing a garbage image, ensure that the signal cables and source are working correctly. Also, check the Scaler Board, Formatter Board and DMD Board.
Why does my Optoma EP1080 shut down automatically?
Your Optoma Projector might be automatically shutting down due to several reasons. If the Lamp LED is flashing red, check the fan and Scalar Board or Formatter Board. If the Temp LED is red or flashing, check the thermal switch and the fan. If the Lamp LED is constantly red, check the lamp, Lamp Driver, Formatter Board or Photo Sensor.
What to do if my Optoma Projector has color abnormalities?
If your Optoma Projector displays abnormal colors, try performing a “Reset (All data)” from the OSD Menu. You can also try to adjust the Color Wheel Index. If the issue persists, check the Scaler Board, Formatter Board, DMD Board, or Color Wheel.
Why is there no light on my Optoma Projector?
If your Optoma Projector has no light, ensure all connectors are securely connected and aren’t broken. Check the Lamp Module, Lamp Driver, LVPS, Scaler Board, Formatter Board, Photo Sensor, and Color Wheel.
Why is my Optoma EP1080 making mechanical noises?
If your Optoma Projector is making mechanical noises, check the Color Wheel and Fan Module.
What causes poor uniformity or shadows on my Optoma EP1080's image?
To address poor uniformity or shadows on your Optoma Projector, ensure the projection screen is free of dirt and that the projection lens is clean. Also, ensure the brightness is within specified limits. If problems persist, check the rod alignment and Engine Module.
What to do if Optoma EP1080 remote control or control panel failed?
If the remote control or control panel of your Optoma Projector is not working, start by checking the battery. If that's not the issue, check the Remote Controller, IR receiver, Scaler Board, Formatter Board, FPC, and Keypad.
General| Resolution | 1920 x 1080 |
|---|---|
| Zoom | 1.1x |
| Display Technology | DLP |
| Input Lag | 16 ms |
| HDMI Version | 1.4a |
| Contrast Ratio | 20000:1 |
| Inputs | HDMI, VGA, USB |
| Projection Size | 30" - 300" |
