What to do if I see a warning message about lamp failure on my Optoma H27?
If you see a warning message indicating that the lamp may fail soon on your Optoma Projector, please contact your local reseller or service center.
How to resolve image flicker on Optoma Projector?
If your Optoma Projector's image is flickering, try performing a “Factory Reset” in the engineering mode. Also, ensure that the signal cables and source are working correctly. Check the Lamp Module, Color Wheel, DMD Board, and Main Board.
How to fix Optoma Projector with no power?
If your Optoma Projector has no power, ensure the power cord and AC power outlet are securely connected. Also, check the Lamp Cover and Interrupt Switch. Make sure all connectors are securely connected and haven’t broken. If these steps don't resolve the issue, check the LVPS, Lamp Driver, and Main Board.
What to do if my Optoma Projector has no image?
If your Optoma Projector shows no image, ensure that the signal cables and source are working. If you connect multiple sources, use the “Source” button on the control panel to switch. Also, make sure all connectors are securely connected and haven’t broken. If the issue persists, check the Main Board, DMD Board, Color Wheel, DMD Chip, and Engine Module.
Why does my Optoma H27 Projector auto shutdown?
If your Optoma Projector is automatically shutting down, check the following based on the LED indicator: If the Lamp LED is lit, check the Lamp Module. If the Temp LED is lit, check the Thermal Sensor Board. If the Temp LED blinks, check the Fan Module. If the Power LED is off, check the LVPS. Also, check the Main Board and Lamp Driver.
How to troubleshoot Optoma H27 with no light on?
If your Optoma Projector has no light, ensure that all connectors are securely connected and haven’t broken. You should also check the Lamp Module, LVPS, Lamp Driver, and Main Board.
What causes garbage image on Optoma H27?
If your Optoma Projector displays a garbage image, ensure that the signal cables and source are working correctly. Additionally, check the Main Board and DMD Board.
How to fix abnormal screen size on Optoma H27?
If the screen size on your Optoma Projector is abnormal, perform a “Factory Reset” in the engineering mode. Additionally, adjust the “Aspect Ratio” settings. If problems persist, check the Main Board.
Why is my Optoma H27 making mechanical noise?
If your Optoma Projector is producing mechanical noise, check the Color Wheel, Fan Module, LVPS, Lamp Driver, and Engine Module.
How to fix poor uniformity or shadows on Optoma H27?
If you're experiencing poor uniformity or shadows with your Optoma Projector, ensure the projection screen is clean and the projection lens is also clean. Verify that the brightness is within specification. If the Brightness is less than the specification, replace the Lamp. Check the Engine Module.
General| Display Technology | DLP |
|---|---|
| Contrast Ratio | 4000:1 |
| Native Aspect Ratio | 16:9 |
| Lamp Life | 3000 hours (normal mode), 4000 hours (economy mode) |
| Projection Size | 26 to 300 inches |
| Inputs | VGA, S-Video, Composite Video |
| Noise Level | 30 dB (economy mode), 34 dB (normal mode) |
To Next Page
