Main
Menu
Sub Menu Sub Menu 2 Sub Menu 3 Sub Menu 4 Values
Setup Reset
Reset OSD
Cancel [Default]
Yes
Reset to Default
Cancel [Default]
Yes
Information
Regulatory
Serial Number
Source
Resolution 00x00
Refresh Rate 0.00Hz
Display Mode
Lamp Hours
Bright 0 hr
Eco. 0 hr
Dynamic 0 hr
Eco+ 0 hr
Total
Filter Hours
Brightness
Mode
FW Version
System
MCU
Note:
The “Lamp Reset” in OSD will only reset both Lamp Hours in OSD and Lamp Hours in service mode.
The Projection Hours in service mode will not be reset.
When you made the changes on the “IR Function”, “Projection”, or “Keypad Lock” function, a
conrmation message will appear on the screen. Select “Yes” to save the settings.
Each display mode can be adjusted and saved the value.
In 3D timing mode, the zoom/edge mask will be disabled to prevent from image break.
To Next Page
Loading...
