Do you have a question about the Optoma S303 and is the answer not in the manual?
display technology | Single 0.55ʺ DC3 DMD |
---|---|
native resolution | SVGA (800 x 600) |
maximum resolution | UXGA (1600 x 1200) & 1080p (1920 x 1080) |
brightness | 3000 lumens |
contrast ratio | 15, 000:1 (full on/full off) |
displayable colors | 1.07 Billion |
lamp life and type | 10, 000/6500/6000/4500 Hours (Education cycle/ECO+/Dynamic/Bright) 190W |
projection method | Front, rear, ceiling mount, table top |
keystone correction | ±40° Vertical |
uniformity | >80% |
offset | 115% |
aspect ratio | 4:3 Native, 16:9 compatible |
throw ratio (distance/width) | 1.97–2.17 |
projection distance | 3.9ʹ–32.8ʹ (1.2–10 m) |
image size (diagonal) | 30ʺ–300ʺ (0.7–7.62 m) |
projection lens | F=2.51–2.69, f=21.95–24.18 mm, 1.1x manual zoom and focus |
digital zoom | 0.8 ~ 2.0 |
audio | 2-Watt speaker |
---|---|
noise level | 26dB |
remote control | IR remote mouse control |
operating temperature | 41–113°F (5–45°C) |
---|---|
humidity | 85% max humidity |
power supply | AC Input 100–240V, 50–60Hz, auto-switching |
---|---|
power consumption | Max 240W (Normal), Min 194W (Eco+), <0.5W (standby-ECO) |
computer compatibility | UXGA, WXGA, SXGA+, SXGA, XGA, SVGA, VGA resized, VESA, PC and Macintosh compatible |
---|---|
video input compatibility | NTSC, PAL, SECAM, SDTV (480i), EDTV (480p), HDTV (720p, 1080i/p) |
3D compatibility | Supports all HDMI 1.4a mandatory 3D format, side-by-side format and top and bottom format |
vertical scan rate | 24–85Hz, 120Hz, 144Hz |
horizontal scan rate | 15.375–91.146KHz |
weight | 4.9 lb (2.21 kg) |
---|---|
dimensions | 12.4ʺ x 4.6ʺ x 8.8ʺ |
i/o connection ports | HDMI v1.4a, two VGA-in, VGA-out, S-video, composite video, two audio-in, audio-out, RS-232C, USB-B |
---|---|
loop through (audio, vga) | Monitor: D-Sub 15 pin VGA output (functional in both normal and standby modes), Audio: VAO audio out, HDMI VAO audio out supported |
Connect the power cord and video source to the projector, and identify key ports.
Switch display output modes using function key combinations specific to computer brands.
Avoid direct exposure to the projector beam to prevent eye injury.
Modify the zoom level of the projected image.
Fine-tune the clarity and sharpness of the projected image.